INDEX
| No | Title | Author |
|---|---|---|
| 1 | On the Denuded Zone in Aluminium-Magnesium Alloys. | M. Adachi |
| 2 | Effect of Composition on the Ageing of Al-Mg-Si Alloys. | H. Asada |
| 3 | Flow Stress of Mg-Li Alloys. | H. Asada |
| 4 | Effect of Homogenizing Heat Treatment on the Hot Workability of Al-Mg-Si Alloys | H. Asada |
| 5 | Studies on the Strength of Welded Joints of Aluminium Alloy Structural Members. | K. Fujita |
| 6 | Study on Cold Extrusion of Aluminium and its Alloys. | J. Seino |
| 7 | Local Corrosion of High Purity Aluminium. | T. Fukushima |
| 8 | On the Production of Wires from Aluminium Strips. | I. Gokyu |
| 9 | The Distribution of Contact Pressure in the Cold Rolling of Aluminium Square Bars. | I. Gokyu |
| 10 | Formation of a Film and Discoloration of Aluminium in a Boiling Solution. | H. Harimoto |
| 11 | On the Feeding Characteristics of Aluminium Alloys (I) | K. Hashiura |
| 12 | Study of the Spinnability of Aluminium Plates (I). The Deformation of the Flange and the Formation of Wrinkles by Shear Spinning | M. Hayama |
| 13 | Study of the Spinnability of Aluminium Plates. (II) The Fracture of Walls on Shear Spinning. | M. Hayama |
| 14 | Calorimetric and Resistometric Analyses of Ageing and Precipitation in Aluminium-Copper Alloys. | K. Hirano |
| 15 | The Grain-boundary Segregation of Fe, Co, and Ni in Aluminium and its Effects on the Mechanical Properties of Aluminium. | K. Hirano |
| 16 | Precipitation Process in an Al-Zn-Mg Alloy. | K. Hirano |
| 17 | Two-step Ageing of an Al-5 wt% Zn-l wt% Mg Alloy. | K. Hirano |
| 18 | Studies of Hyper-eutectic Al-Mn Alloys. (I) Their Fundamental Properties as Casting Alloys. | R. Ichikawa |
| 19 | Studies of Hyper-eutectic Al-Mn Alloys. (II) Temperature of Recrystallization and Extruded Structure of Al-4% Mn Alloys. | R. Ichikawa |
| 20 | Studies of Hyper-eutectic Al-Mn Alloys. (III) Effects of a Third Alloying Element on the Cast Structure of Rapidly Cooled Al-3-5% Mn Alloys. | R. Ichikawa |
| 21 | The Shapes of Bulged Surfaces of Aluminium Foils. | S. Inada |
| 22 | Study on the formation of Pits on the Surface of an Aluminium Sheet Immersed in Synthetic Waters. | S. Ishida |
| 23 | Preferential Strain-hardening near the Surface of Aluminium Single Crystals. | H. Kaieda |
| 24 | The Phase Diagram of the Al-Si-Ti Equilibrium System. | K. Kamei |
| 25 | Studies on Dynamic Corrosion of Aluminium and its Alloys in Tap Water. | M. Kato |
| 26 | The Behaviour of the Grain Boundary of Aluminium-base Alloys under Plastic Working. | M. Kato |
| 27 | Direct Observation of the Multiplication of Dislocations in Thin Foils of Aluminium Alloys. | S. Koda |
| 28 | Studies on the Cutting Temperature of Aluminium Alloys. | K. Kurihara |
| 29 | On the Adhesiveness of Aluminium Plate to Aluminium Enamel by Anodic Oxidation (D.C.) and the Diagram of Surface Potential. | S. Maruno |
| 30 | Study on Aluminium Enamels. | S. Maruno |
| 31 | Surface Defects of Aluminium-alloy Welding Wires. | K. Matsubara |
| 32 | Grain Boundry Sliding in High-purity Aluminium (99.999%) Bicrystals during Shearing Test under Constant Stress and Constant Rate of Heating. | G. Mima |
| 33 | Grain-boundary Sliding in High-purity Aluminium (99.999%) Bicrystals during High-temperature (Isothermal) Shearing Test. | G. Mima |
| 34 | Creep Rupture Strength of Aluminium Specimens. | S. Miyano |
| 35 | Nonlinear Bending of Rings under Uniform External Pressure. | M. Mizuno |
| 36 | Determination of Residual Phosphorus in Hyper-eutectic Aluminium-silicon Alloys. | S. Morita |
| 37 | Thermodynamic Study of Al-Si Binary Alloys. | J. Moriyama |
| 38 | On the Precipitation in Aluminium-Zinc-Magnesium Alloys. | Y. Murakami |
| 39 | Untersuchung über die Ausscheidung in der Aluminiumlegierung Mit 7 gew.-% Mg unt den Einfluss der Zusätze von Dritten Elementen, Besonders Silber, auf ihr Verhalten. | Y. Murakami |
| 40 | Studies on the Control of the Grain Size of an Aluminium Sheet. (I) Effect of La, Ce, and Misch-metal on the Grains of a Pure Aluminium Sheet. | S. Muromachi |
| 41 | Effect of TiC, TiC-WC, TaC-WC and WC on the Grain Refinement of Pure Aluminium. | Y. Nakao |
| 42 | Potential-controlled High Frequency Polarography. | E. Niki |
| 43 | On the Behaviour of Gases in Aluminium and its Alloys. Effect of Silicon in Aluminium-silicon Alloys on the Absorption of the Gas Produced by the Mould Reaction. | S. Nishi |
| 44 | The Electrical Conductivity and Activation Energy for Ionic Conductance of Fused Salt Mixtures. | K. Nishihara |
| 45 | On Fatigue Fracture of Age-hardening Aluminium Alloys. | Y. Takeuchi |
| 46 | The Characteristics of Fatigue Crack Propagation in Al-Mg2Si and Al-Mg Alloys. | I. Obinata |
| 47 | On Some Changes in the Early Stage of Fatigue of Al-Mg2Si Alloys. | I. Obinata |
| 48 | The Reversion of the G.P. Zones in Al-Mg2Si Alloys under Cyclic Loading and their Reformation after Unloading. | Y. Takeuchi |
| 49 | Effect of a High Magnetic Field on the Solidification of Aluminium Alloys. | Y. Takeuchi |
| 50 | Study of the Al-Mg2Si-Mg2Sn Quasi-ternary System. I. The Age-harden-ing of Al-Mg2Si-Mg2Sn Quasi-ternary Alloys. II. The Phase Diagram of Al-Mg2Si-Mg2Sn Quasi-ternary System. | I. Obinata |
| 51 | Stress-corrosion Cracking of Welded Aluminium Alloys. | N. Ohtani |
| 52 | Study on the Wear of Casting Aluminium Alloys. (III) Influence of Silicon Content and Grain size of Primary Silicon Crystals on the Wear Characteristics of High-Silicon Aluminium Alloys. | K. Okabayashi |
| 53 | Influence of Deep-drawing Conditions on the Earing of Aluminium Single Crystals. | K. Okada |
| 54 | Primary Crystallization in the Hypo-eutectic Aluminium-Silicon Alloys. | S. Oya |
| 55 | Study on the Fluidity of Ternary Al-Cu-Si Alloys. | R. Ozaki |
| 56 | Plastic Anisotropy of Aluminium. On the Stress and Strain of Tubular Specimens under the Combination of Internal Pressure and Axial Load. | K. Saito |
| 57 | Radioactivation Analysis of Trace Elements. (I) | N. Saito |
| 58 | Deformation of Aluminium Single Crystals in the Impact Tensile Test and their Direct Observation with an Electron Microscope. | S. Sakui |
| 59 | Behaviour of Aluminium Single Crystals under Dynamic Loading. | S. Sakui |
| 60 | Work Softening and its Effect on the Yield Point of Magnesium Single Crystals Given Preliminary Dynamic Straining. | S. Sakui |
| 61 | On the Mechanical Properties of Aluminium Strained by Impact Loading. | S. Sakui |
| 62 | The Flow of Aluminium on the Surface of Solid Steel and the Effect of Fluxes used in Hot Dipping. | F. Seki |
| 63 | The Growth of Whisker-type Crystals on the Surfaces of Some Al-Mg Alloys Heated in a Vacuum. Direct Observation of the Transforma-tion in the Alloy under a High-temperature Microscope (I). | K. Shimizu |
| 64 | On the Grinding of Aluminium. | K. Sugaya |
| 65 | Studies on the Low-melting Enamel of the PbO·Sb2O3 System. | H. Tagai |
| 66 | Orientation of the Crystals of Lead Antimonate and Tartrate on the Surface of an Aluminium Porcelain Enamel. | H. Tagai |
| 67 | A Study on the Thermal Reduction of Magnesium by Silicon (III). Effect of Additions. (II) | S. Takagi |
| 68 | The Effect of Thickness and Mechanical Polishing on the Development of Precipitates in Light Alloys. | N. Takahashi |
| 69 | Superficial Plastic Deformation due to Surface Finishing Revealed by Preferential Precipitation in an Al-25% Ag Alloy. | N. Takahashi |
| 70 | Production of Lattice Defects in Aluminium and the Deformation Temperature. | J. Takamura |
| 71 | Quenched-in Vacancies in Dilute Al-Si Alloys. | J. Takamura |
| 72 | Determination of the Vacancy-impurity Binding Energy and Entropy from Quenched-in Resistivity Measurements in Dilute Aluminium Alloys. | J. Takamura |
| 73 | The Fatigue Fractography of Aluminium Alloys. | Y. Takeuchi |
| 74 | Optical Studies on Anodic Oxide Films on Aluminium (I). Optical Analysis of the Mechanism of the Formation of α-Alumina Films. | S. Tajima |
| 75 | Mechanism of the Formation of a Conversion Film on Aluminium in an Alkaline Chromate Solution. | S. Tajima |
| 76 | Contact Corrosion of Bimetallic Couples of Aluminium or Anodized Aluminium with Mild Steel or Stainless Steel in Inorganic Corrosion Media. | S. Tajima |
| 77 | The Wear Resistance of Hard-Anodized Coatings (III), (IV). | S. Ueda |
| 78 | Studies on the Creep of High Purity Aluminium. | H. Watanabe |
| 79 | Studies of Electrophoretic Aluminium Coating on Steel Plate (I). Examination of Suspension in Electrophoresis for Aluminium Electrodeposition. | T. Yamada |
| 80 | Studies of Electrophoretic Aluminium Coating on Steel Plate (II). The Effect of the Conditions on the Electrodeposition of Aluminium by Electrophoresis. | T. Yamada |
| 81 | Studies of Electrophoretic Aluminium Coating on Steel Plate (III). The Examination of the Mechanism of the Electrophoretical Deposition of Aluminium Powder. | T. Yamada |
| 82 | Studies of Electrophoretic Aluminium Coating on Steel Plate (IV). The Structure of Aluminium-coated Steel Plate. | T. Yamada |
| 83 | On the Abrasion of the Tooth-face and the Tooth-flank of an Aluminium and an Aluminium Alloy Gear. | S. Yonetzu |
| 84 | Effect of Additives on Steam Sealing for Aluminium Finishing. | C. Yoshimura |
| 85 | Direct Conductimetric Titration of Aluminium with Carboxylic Acid Derivatives in Nonaqueous Media and its Application to Determi-nation of Ionic Aluminium in Aluminium Finishing Solution. | C. Yoshimura |
| 86 | Application of Internal Electrolysis to Chemical Polishing of Aluminium. | C. Yoshimura |
| 87 | Direct Observation of Secondary Defects in Al-Zn Alloys. | S. Yoshioka |
| 88 | Study on the Machinability of Aluminium Alloys (I). On the Machinability of Wrought Aluminium Alloys. | S. Zaima |
| 89 | Study on the Machinability of Aluminium Alloys (II). On the Drill-machinability of Wrought Aluminium Alloys. | S. Zaima |
| 90 | Study on the Machinability of Aluminium Alloys (III). Effect of Silicon on the Machinability of Aluminium-Silicon Cast Alloys. | S. Zaima |
| 91 | Study on the Machinability of Aluminium Alloys (IV). On the Machinability of Copper Silimin Pressure Die Castings | S. Zaima |
| 92 | Study on the Machinability of Aluminium Alloys (V). Influence of the Cutting Tools on the Machinability of 17S and 56S under High Speed Turning. | S. Zaima |
| 93 | Study on the Machinability of Aluminium Alloys (VI). Study on the Countersinking of Aluminium Sheets. | S. Zaima |
| 94 | Study on the Machinability of Aluminium Alloys (VII). Effect of Copper on the Machinability of Aluminium-Copper Alloy Castings. | S. Zaima |
| 95 | Study on the Machinability of Aluminium Alloys (VIII). Some Problems on the Turning of Aluminium Alloy Castings. | S. Zaima |